If you watched the video of Mike  from Mikeselectricstuff tearing down an Anritsu spectrum analyzer, you might have seen some weird shapes on the PCB that just don’t seem to make any sense. In case you missed the video, check out the last few minutes of it to know what I am referring to:
All pictures in this article are courtesy of Mike.
I am not going to explain the functionality of each and every circuit in great detail. As a matter of fact, I will try not to explain anything at all. Each circuit alone is enough for an individual article just on that type of RF circuitry. Therefore, I will add an article about every individual circuit shown here (and many more) shortly. The articles will contain much more detail including info on how to design them yourself.
Now let’s pick out some of the weird shapes on the PCB of Mike’s Anritsu spectrum analyzer and identify them.
The first close-up is a hair-pin type band-pass filter. To keep it short, they are nothing else than loosely coupled LC resonators. Because parasitic capacitance and inductance is high enough to use them as filter elements in the GHz range, there are no actual discrete parts, such as inductors and capacitors, needed. Filters like this are called ‘distributed element filter’.
Next up is a distributed element low-pass filter. The rectangles on the top are capacitors and constitute a series resonator together with the vertically aligned strip-lines. Since series resonators are having a low impedance at their target frequency, they can be used as low-pass filters in this configuration. Basically what they do is sort out the unwanted signals at the resonance frequency of the series resonator.
The next picture shows a close-up of several radial stubs. They are extremely common to implement RF shorts that pass though DC voltages. Just like the aforementioned low-pass filter, radial stubs are nothing else than a series LC resonator. They have multiple applications. One is to notch out an unwanted signal. DC bias voltage PCB traces often have a radial stub on them to make sure no unwanted RF makes its way into the DC rail.
Okay, that’s the pre-tease for the upcoming Microwave Circuit Design 101 (MCD101) article series. This new series of articles will definitely serve a good experimental purpose; Either it will prove that RF circuit design is not at all black magic or it will prove that I a Voodoo master. I would feel comfortable with either outcome.
Links and Sources:
 Mikeselecricstuff: http://www.electricstuff.co.uk/