Over the past weeks I had KF5FBR’s Yaesu FT101E ad N5WSA’s Icom IC-718 on my bench for various services. The FT-101 needed a general health check and brand new capacitors. No output powers was the problem the IC-718. The latter was caused by burned out final transistors. While working on them, I shot some pictures […]
Continue reading…
Search Results for: odu repair
Repairing a MRC DAR Plus Receiver
This is another piece of industry story time. This time it’s about Vislink MRC DAR Plus receivers and transmitters. It shows that even highly integrated devices in the 1 each including shipping. After carefully replacing the MMIC on the PCB, I tested the IF module by applying a 70 MHz signal again. This time the […]
Continue reading…
Fixing a microstrip line in a professional Microwave ODU
A while back, I was asked if I could repair a ODU for a BMS Truck-Coder II. Someone had managed to rip the N connector straight off the casing, including a bit of the microstrip line from the distributed element output filter. See what approach I took to fix the broken stripline. The BMS Truck-Coder […]
Continue reading…
SITOR-B / NAVTEX Test Signal Generation
This article shows how to generate valid NAVTEX message bitstream using an Arduino. The Arduino implements proper CCIR476 character encoding, SITOR-B forward error correction, synchronization and phasing signals. An entry-level function generator is then used as a FSK modulator on 518 kHz where it can be received by a NAVTEX receiver. UPDATE: There also is […]
Continue reading…